Masks for the glazing of the S-Kauba SK-257 in 1:72 scale from Brengun. The manufacturer created them for its own kit of this machine.
Responsibility details are not available.
A set of shaped masks for the cockpit, which the manufacturer describes as stencils for spraying the glazing of its SK-257 kit. It is not a model or a replacement canopy: they are pre-cut pieces that cover exactly what is to stay clear on the clear surface, so that you spray the frames of the cockpit without laboriously cutting tape.
Masking a cockpit by hand is the most common cause of work ruined in the last phase of a build in a small scale: tape cannot be laid exactly along the frame, paint creeps under it and the clear part gets scratched. A pre-cut mask follows the shape of the glazing, so the edge of the transition is sharp and the work faster. The advantage grows on multi-part cockpits with curved surfaces, where laying tape by hand is hardest.
First wash and degrease the glazing, seat the mask with tweezers and press it down with a wooden toothpick, so that no gap is left at the edges. Apply the paint in several thin coats, as a thick coat creeps under the mask. Lift the mask shortly after it has dried, because with fully cured paint the edge tears. Glue the finished glazing with a canopy cement, as cyanoacrylate glue will fog the clear part.
This is an add-on for a model. The base SK-257 kit from Brengun, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
