1:72 15 cm sIG 33 Heavy Infantry Gun is a resin 3D printed kit for experienced modelers - a model of the towed German heavy infantry gun itself, not the self-propelled version and not an ammunition set.
Responsibility details are not available.
This is a resin 3D printed kit for experienced modelers, and that of a model of the towed gun itself, the 15 cm sIG 33. The manufacturer states that the package contains a complete 3D printed kit in resin intended for more experienced modelers and that it is supplied unpainted and unassembled. The parts sit on printing supports.
The 15 cm sIG 33 heavy infantry gun, in full schweres Infanteriegeschütz 33, was among the standard heavy infantry weapons of the German army of the Second World War. It gave the infantry heavy fire support with an effective range of around 4700 meters and a rate of two to three rounds per minute; elevation ran from zero to roughly 73 degrees. It was used in towed form and its barrel became the basis of the armament of several German self-propelled guns, for example the Bison on the Panzer I chassis or the Grille.
Cut the printing supports off carefully and clean the parts up; protect your airways when sanding, as resin dust is not to be inhaled. Wash the parts before painting and glue with cyanoacrylate glue - ordinary cement for plastic will not join resin. A primer coat is mandatory. The shield and the barrel are the most delicate, so glue them on a flat surface and let them cure.
The model is supplied unassembled and unpainted. Glue, paints and accessories are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
