KAMAZ 65115 detailing set (Quinta Studio) is printed resin detail parts for the Zvezda kit of the KAMAZ 65115 dump truck.
Responsibility details are not available.
A set of printed resin detail parts for the kit of the KAMAZ 65115 dump truck from the Russian brand Quinta Studio. The box gives the KAMAZ from Zvezda as the target kit. The scale is not stated here: the figure on the box and the manufacturer's number series contradict each other, and with an accessory the wrong scale is the most expensive mistake. This is an accessory to a kit, not a model of the vehicle.
The KAMAZ 65115 is a three-axle dump truck, the workhorse of builders' yards and quarries. It has a short cab over the engine, a sturdy frame and a tipping body for bulk loads. For the modeler it is interesting for what passenger cars lack: the exposed frame, the tanks, the air reservoirs and the tipping hydraulics are all clearly visible, so added detail here shows at first glance.
Printed resin parts are hard and brittle, so handle them with care. First wash them in warm soapy water so that the print resin residue disappears from the surface and the paint will hold. Cut off the supports with a saw or a cutting disc, never with nippers. Sand the mating surface flat and glue the parts with cyanoacrylate glue or epoxy, because cement for plastic will not hold here. Wear a respirator while sanding, or sand wet.
This is an accessory to a model, not a kit. The base kit, paints and glue are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
