Turnbuckles 7.5 mm are 3D printed resin turnbuckles from Firma49 for faithful rigging on aircraft models.
Responsibility details are not available.
These are 3D printed resin turnbuckles from Firma49, not a model of their own. The length of one turnbuckle is 7.5 mm. They serve for a realistic rendering of the rigging and bracing typical of biplanes and older aircraft. There are a good number of them in the package so that they cover a whole model.
Turnbuckles are small connecting elements that in reality tensioned the steel wires between the wings and the fuselage. On a model they look very faithful when they terminate rigging stretched from drawn sprue, monofilament or wire.
Separate the parts carefully from the supports and clean them up; the resin can be softened briefly in hot water before cutting or drilling so that it does not chip, and it hardens again once cooled. It is bonded with super glue and takes ordinary modeling paints easily. We recommend fine tools and good lighting.
The accessory is supplied unassembled and unpainted. Glue, paints and the rigging wire are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
