A clear air hose 1.5 m long with a type S connector, that is PF1/8, from Tamiya. It is intended for the HG Revo II compressor as well as other air sources and withstands pressure up to 0.15 MPa.
Responsibility details are not available.
The hose connects the air source with the airbrush. It is 1.5 m long, made of a clear flexible material, and carries a type S connector, that is PF1/8, the most widespread thread size on hobby airbrushes. The manufacturer specifies it for the HG Revo II compressor and for other air sources. It is designed for operation at a pressure of 0.15 MPa or lower. The manufacturer is Japan's Tamiya.
Before buying, check the thread size on your airbrush and on the air source. PF1/8 is the most common, but not the only size in use, and without a matching adapter an airbrush with a different fitting will not connect. Observe the upper pressure limit of 0.15 MPa; at higher pressure the hose is not designed for this work. Tighten the joints by hand and only gently, because overtightening damages the thread. The clear material has a practical advantage: you can see right away when moisture or paint gets into the hose. Do not bend the hose over a sharp table edge, and after work leave it loosely coiled.
It suits owners of the HG Revo II compressor who need a replacement or a second hose, and anyone putting together an airbrush workstation from parts who is looking for a hose with the common PF1/8 thread in a length that fits on a desk.
The airbrush and the air source are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!