Yamaha YZR-M1 (2007) 3D-Printed Clutch, Chain and Sprocket is a 3D printed set in 1:12 scale from Decalcas for the Beemax kit. It is not a kit.
Responsibility details are not available.
A 3D printed detail set in 1:12 scale from the Decalcas brand: the clutch, the chain and the sprocket for a model of the Yamaha YZR-M1 motorcycle in its 2007 form. It is neither a kit nor a finished model — it is a replacement for the kit parts of the drive. The manufacturer intends it for the Beemax kit number 13002.
The Yamaha YZR-M1 is a prototype for the premier class of the road racing world championship. The year 2007 was a turning point in that class: engine capacity was reduced from nine hundred and ninety to eight hundred cubic centimeters, so the machines were given new engines and differently set up chassis. On a motorcycle the drive is visible in full — the chain, the sprocket and the clutch basket are not covered by anything — and a simplified kit part therefore spoils an otherwise finished model.
Dry-fit the chain and the sprocket and check both the pitch and the sag before you glue anything: a chain stretched tight or conversely hanging slack shows on a model at once. Glue the small 3D printed parts in spots with cyanoacrylate glue, because ordinary cement for plastic will not bond them. A primer is essential, otherwise the paint will not hold. Metal on a drive looks best layered and then slightly flattened.
This is an accessory for a model, not a kit. The base kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
