1:72 MBD2-67U multiple bombs racks (2 pcs)

Reskit 1:72 MBD2-67U Multiple Bomb Racks (2 pcs)

The set includes two multiple bomb racks MBD2-67U in 1:72 scale, cast/printed in resin. This is an accessory, not an aircraft model — and note, these are not the bombs themselves, but the racks from which bombs are hung. The manufacturer is Reskit, a specialist in resin and 3D-printed detail parts for aircraft models.

The Real Subject

The MBD2-67U is a Soviet multiple bomb rack (in English, a multiple bomb rack). It attaches to a standard hardpoint under the wing or fuselage and lets several bombs be hung from a single pylon instead of one. This significantly increases the number of bombs the aircraft can carry and gives the model the typical fully loaded combat configuration. Multiple racks of this type appear on Soviet and Russian combat and attack aircraft, for which they are a characteristic part of the underwing ordnance.

Use and fitting

• Remove the casting blocks and print supports with a sharp knife, cutter, or fine saw.
• Wash the parts with lukewarm water and dish soap — this removes residual mold-release agent.
• Glue with cyanoacrylate (super glue); plastic cement does not hold on resin.
• Sand resin wet and with respiratory protection; apply a primer before painting.
• Fit the racks onto the model's pylons first, then hang the bombs on them (not included in the package).

Who the set is for

For modelers building Soviet and Russian combat aircraft in 1:72 scale who want to build an authentic underwing configuration with multiple racks. The set will especially appeal to those missing them from the box, or who want to replace coarser plastic parts. Working with resin requires cyanoacrylate glue and a bit of patience cleaning up the parts.

This is not an aircraft model or bombs, but accessory racks. It is supplied unassembled and unpainted; glue, paints, bombs, and the base model are not included in the package.