Gaahleri air hose: the connection between an airbrush and a compressor, a spare part as well as an addition to a setup.
Responsibility details are not available.
A hose for connecting an airbrush to a compressor. It is the part most often forgotten when a setup is put together, and yet it is precisely what decides how comfortable the work is: a short hose pulls the gun out of your hand, a stiff one restricts movement, and a joint that does not seal means the compressor runs all the time. A hose is also bought as a replacement, because it wears out from being bent at the fitting.
Before buying, check the size of the threads on your airbrush as well as on your compressor, because there are several widespread sizes and adapters are used between them. Tighten the joints by hand and only gently; overtightening damages the seal. If a joint leaks, sealing tape for the thread usually helps. Do not run the hose over the edge of a table, where it kinks, and do not leave it under pressure after work, which will extend its life.
For anyone who sprays with an airbrush, whether they are building a new workplace or replacing a worn part. A second hose also pays off for anyone who works with two guns and does not want to swap them over every time the color changes.
This is a part for working with compressed air. Always release the pressure before working on the setup and do not use a damaged hose. Store it out of reach of children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
