Gunze GT65G - a spare 0.70 mm scriber blade for the Mr. Line Chisel GT-65. The coarsest edge in the range, for deep, prominent lines on large models.
Responsibility details are not available.
A spare scriber blade 0.70 mm wide from the manufacturer Gunze / Mr.Hobby (GSI Creos) for the panel line scriber Mr. Line Chisel GT-65. It is a blade on its own - to be able to use it you have to have the GT-65 scriber (the handle) that it clamps into. The blade alone, without the scriber, does not work.
Parting and panel lines on a model are only shallow from the factory and vanish under a clear coat; after sanding seams down they are lost altogether. A scriber deepens them so that they stay legible and can be brought out with a wash. Engraving is done by pulling - the edge scrapes along the surface repeatedly, in light strokes guided by a template or tape, never in one deep cut at once. The burr is then smoothed away with a sanding sponge.
For modelers of large models and dioramas who need really prominent, deep lines. Always choose the width according to the scale - a coarse blade creates a trench on a small model, and a fine one disappears on a large one. That is why modelers tend to keep several widths; the GT-65 range covers roughly 0.10 to 1.20 mm and a needle variant completes it. Everything clamps into the same GT-65 scriber.
The blade is very sharp - handle it carefully, draw the strokes away from yourself and keep out of the reach of children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
