A steel seat harness for the Macchi MC.202 from the Czech maker Eduard is a photo-etched set cut to fit the Italeri kit in 1:48 scale. It is not a model but an accessory.
Responsibility details are not available.
This is not an airplane model but a set of seat harnesses of photo-etched steel for the Macchi MC.202 kit in 1:48 scale from the maker Italeri. The series code corresponds to the smaller version that Eduard lists as Zoom: the parts are pre-painted, so the modeler only shapes them and seats them.
A seat harness modeled in plastic looks as if hewn from stone, because fabric and metal buckles are the thickness of paper in scale. A photo-etched steel harness is thin, it can be bent and thrown over the edge of the seat and by its own shape it gives away that somebody sat in the cockpit. And that look of the seat is the first thing to catch the eye on a finished model with an open cockpit.
Cut the parts out of the sheet on a hard surface; do not break them out with your fingers. Make the bends in a bender or between two blades so that the edge comes out sharp and the same along its whole length. They are glued with cyanoacrylate, that is, super glue; apply it with a pin, not straight from the bottle. Before painting, degrease the metal and give it a primer for metal, otherwise the paint will not hold on the smooth surface. The plastic part the set replaces usually has to be sanded away first.
The set is supplied unassembled and unpainted as photo-etched metal. The base kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
