German water jerrycans 1:35, twelve pieces from Plusmodel: a printed set of twenty-liter water cans. It is not a kit.
Responsibility details are not available.
At first glance a water can looks the same as a fuel one, and that is precisely why the two had to be told apart unmistakably: the water ones carried a white cross and lettering so that nobody would pour gasoline into the field kitchen. For a modeler this is a rewarding detail, because a couple of white markings among dark cans brings a scene to life at once. The set brings twelve jerrycans made by 3D printing with crisp pressed ribs and handles. It is an accessory, not a kit.
The package contains twelve printed water cans in 1:35 scale. Holders, decals, paints and glue are not included. The parts are unpainted and have to be cut off the support structures.
Cut the parts off with a sharp scalpel and level the surfaces with a fine file; sand with respiratory protection. They are bonded with cyanoacrylate, that is with super glue. Paint the white markings only onto a finished base coat and leave them slightly irregular, because in the field they were renewed by hand. Let a dark seeping wash run into the pressed ribs, add rubbed metal on the edges with a drybrush and a deposit of dust from pigments on the lower part.
The set is supplied unassembled and unpainted. Glue, paints and accessories are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
