The Airbrush Holder is a stand for resting an airbrush that holds it safely and within reach.
Responsibility details are not available.
A holder in which the airbrush is rested between one spraying session and the next. An airbrush left on the table is easy to knock over, the paint runs out of the cup and the needle bends in the fall. The stand prevents that and at the same time holds the airbrush in a position from which it can be picked up again quickly.
Place the stand so that the airbrush hangs over the extracted area; a drop of paint from the nozzle then does not land on the table. Route the hose loosely and do not let it pull on the airbrush, or you will drag the stand over. Rest the airbrush with the cup upwards and, during a longer break, flush it rather than not, as dried paint in the channel means more work later than a minute of cleaning. Keep free space around the stand so that the airbrush goes back into it smoothly.
If you add a flushing pot beside the stand, the whole cycle of filling, spraying and cleaning is in one place and you do not have to put the airbrush down between the steps at all.
After work, clean the dried drops of paint off the stand.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
