1:32 F-35B Lightning II - closed canopy frame (3D Printed) is a printed canopy frame in the closed position. It is an addition to a kit, not a model of the aircraft.
Responsibility details are not available.
A set made by 3D printing that replaces the canopy frame on a model of the F-35B aircraft in 1:32 scale, in the variant for a closed canopy. Printing can draw out the section of the frame, the sealing strips and the mountings to the form that an injection mold has to simplify because of the parting line. The frame can moreover be painted separately, so the usual problem of paint running over the edge of the glazing does not arise on the finished model. The set is not a model of the aircraft.
The F-35B is the variant of the Lightning II with the ability to take off in a short distance and land vertically. On the whole family the canopy is a one-piece hinged unit with a prominent frame that divides the silhouette of the forward fuselage in photographs. On the inside it carries the emergency egress items and the lip that beds down onto the fuselage. These are precisely the parts that are visible on a model even with the canopy closed.
The printed parts are held on thin supports. Snip them off close to the part and level the face with a file or a scalpel. They are glued with cyanoacrylate glue (super glue). Paint the frame separately before you set it onto the glazing, and use a glue for clear parts that will not fog the surface. Try the fit dry before fitting it.
This is an accessory, not a complete model. It is supplied unassembled and unpainted.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
