The closing, third photo-etched set in 1:35 for the DUKW amphibious car completes the remaining fittings, holds and thin sheet-metal elements. The set is intended for the Italeri kit.
Responsibility details are not available.
The third set of the Royal Model line for the DUKW amphibious vehicle is devoted to the remaining small items: the holds, the fittings and the thin sheet-metal elements that decide the overall impression on a finished model. It is assumed that you already have the plastic model part-built. It is based on the dimensions of the Italeri kit.
The cargo bed took about two and a half tons of material or two dozen soldiers and it was open, so the load could be passed over the side straight from the deck of a landing ship. That is precisely why the inside of the load area stays visible on a model and is worth fitting out. After the war the vehicles did not end up as scrap: they served with rescue services, accompanied expeditions into frozen regions and to this day carry tourists along rivers and lakes, which has made them one of the longest-used types of their era. The driver did not take to the water blindly, though: before going in he switched on the pumps and checked the seals of the hatches.
A scene at a loading ramp is a suitable subject for a display case as well. Tweezers with fine points and a work surface with a raised edge will save a great deal of searching on the carpet. Transfer the glue to a part with the head of a pin. If the metal does not want to bond, sand the point of contact with fine abrasive paper.
A model of your own and ordinary modeling equipment are necessary.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
