1:72 F-16 Fighting Falcon (F110-GE-129) - open exhaust nozzle (3D Printed) is a printed exhaust nozzle in the open position. The set is cut for the Revell kit.
Responsibility details are not available.
A printed replacement for the engine exhaust nozzle on a model of the F-16 fighter in 1:72 scale, in the variant for the F110-GE-129 powerplant and with the petals in the open position. The set is cut for the Revell kit. That matters because the same nozzle also comes out in a version for another kit, and the designation of the engine would not tell the two apart. It is an addition to an existing kit, not a model of the aircraft.
Some F-16 machines received a powerplant from an entirely different maker than the rest. The F110 series engine differs from the rival unit outwardly as well: the rear end of the fuselage has a different shape and the nozzle petals a different geometry and length. The difference is apparent even at normal viewing distance, so with a model it pays to find out beforehand which engine a particular machine and its production block had. The open position of the petals matches a parked aircraft.
The printed parts are held on thin supports. Snip them off close to the part and level the face with a file or a scalpel. They are glued with cyanoacrylate glue (super glue). Apply a primer before painting. Leave the inside of the nozzle lighter, tone the outer petals toward a darker, heat-stained shade and bring out the edges with a dry brush.
This is an accessory, not a complete model. It is supplied unassembled and unpainted.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
