Twenty drill bits in diameters from 0.3 to 1.6 mm, arranged in a regular series in steps of five hundredths of a millimeter.
Responsibility details are not available.
The range starts at 0.30 mm and rises in steps of five hundredths all the way to one millimeter, so there are no gaps between the individual sizes. Above one millimeter the series jumps in tenths through 1.20 and 1.30 to 1.40, 1.50 and ends at 1.60 mm. A modeler will therefore find a matching diameter for almost anything, from a hole for a thin wire to the mounting of a grab handle.
Most often it is a matter of drilling out the muzzle of a barrel, holes for wires and antennas, exhaust outlets, or preparing holes for metal pins from photo-etched parts. The smaller sizes also help when removing a gate, when the material first has to be lightened by drilling and only then cut away.
With the finest diameters work without pressure, otherwise the shank breaks easily. Drill slowly, pull the tool out and clear the removed material from the hole. Starting the hole with a fine point stops the bit skidding across a smooth surface. Keep the set in its package so that the cutting edges do not knock against one another.
You can tell a blunt bit by the way the material behaves: instead of being cut away, it is squashed and a lip rises around the hole. Do not go on using such a piece. The risk is not slow work but that it bites in and breaks off inside the part, from where the remnant comes out only with difficulty and often with marks on the surrounding surface.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!