Whizzer Super Fast Low

Whizzer Super Fast Low – fast super glue (AK Interactive)

Whizzer Super Fast Low is a super glue (cyanoacrylate, CA) from AK Interactive. It is a modeling product, chemistry, not a kit and not a model. The word Low (low density) means a thin consistency: the glue wicks easily and runs into tight seams and onto small contact areas. Super Fast then refers to a formulation with additives that evaporate quickly on contact with air – the joint therefore holds noticeably sooner than with ordinary super glues.

Use

• Gluing small parts with a minimal mating area – small accessories, grab handles, antennas, parts from accessory sets.
• Situations where pressure cannot be held for long – the part only has to be pressed on for a brief moment.
• Capillary flow into narrow seams – thin glue draws itself into the joint, so it is enough to touch the edge.
• Gluing resin, 3D prints, photo-etched parts and metal parts, where ordinary cement for plastic does not hold.
• Apply a small amount – with thin CA, more glue does not strengthen the joint, it only runs across the surface.

Who it is for

For modelers working with accessory sets, resin and 3D printed parts or photo-etched parts who need a fast and at the same time precise joint. Thanks to the fast reaction it also suits repairs and late additions in the closing stages of a build. Where there is a gap or an unevenness in the joint, or where you are gluing on a vertical surface, reach for the high density variant instead – thin glue would run out.

Safety: cyanoacrylate bonds skin and fingers instantly. Work in a well-ventilated room, protect your eyes and skin (the vapors irritate the mucous membranes and the eyes), wear gloves and do not work with an open bottle over a finished model. Keep out of the reach of children. If skin is bonded, do not use force, and if the glue gets into the eyes see a doctor. Follow the instructions and the safety data sheet from the manufacturer.