A set of 3D-printed jacks with a ten-ton capacity, the stowed tools of German equipment from the Second World War.
Responsibility details are not available.
A heavy-duty jack was one of the tools German vehicles carried with them during the Second World War so that the crew could deal with a damaged wheel or a loose road wheel without outside help. It was carried fixed to a fender, on the side of the body or at the rear, so it is just as visible on the finished model as on the real thing. The name of this set gives a capacity of ten tons.
These are 3D-printed jack parts intended to add to models of military equipment. Printing can manage even very thin elements that would otherwise have to be replaced with bent wire, so the shapes come out crisp and clean. How many pieces the set contains is in the manufacturer's description.
The printed parts are held on print supports. Cut them off with a sharp blade a little away from the part and carefully sand down the rest with fine abrasive paper so as not to take any detail away. Wash and degrease the parts before painting and apply a primer, or the paint will hold poorly on the smooth surface. Polystyrene cement is no use here; cyanoacrylate glue (super glue) is used instead. Hold small parts with tweezers and cut away from yourself.
The set is for modelers building German equipment who want to add the tools stowed on the vehicle, and for builders of dioramas, where a jack serves as a prop by a vehicle under repair. In the package are the printed parts alone; the model, paints and glue are not supplied with them, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
