Drill Bit 0.4mm L10-04

Mineshima 0.4 mm modeling drill bit

A single twist modeling drill bit 0.4 mm in diameter for drilling fine holes in plastic, resin, wood and soft metals. It is best used in a hand drill (a pin vise), where you have full control over the speed and the pressure and there is no risk of overheating or of tearing the material out as there is with power tools.

Use

• Fine holes for thin wires, antennas and tubing in small scales.
• Pre-drilling holes for metal wires and small pins.
• Detailing plastic kits and resin accessories.
• Drilling by hand with full control over the depth and the position of the hole.

Who it is for

For modelers who need fine and accurate holes while detailing. Because of its small diameter the bit is fragile and calls for a sensitive touch.

Thin bits are fragile, so drill slowly, squarely and without side pressure, so that they do not break. A hand drill (a pin vise) is not included in the package, unless stated otherwise.