Fire extinguishers for German vehicles of the Second World War in 1:48 scale. Four printed parts with a fine surface that will replace the coarse plastic molding.
Responsibility details are not available.
A set of four fire extinguishers for German vehicles of the Second World War in 1:48 scale. It is an accessory, not a model. The parts are made by 3D printing from resin, so they have a clean cylindrical body, a distinct head with a valve and fine details of the mount, which get lost in plastic at this scale.
A portable fire extinguisher was part of the required equipment of combat and cargo vehicles alike. It used to be held in a bracket on the fender, on the wall of the cargo bed or inside the fighting compartment near the driver's position. The engine and fuel section of a vehicle burned fast and a crew had only a few seconds to act, so the extinguisher had to be at hand. On a model it is one of the features that give away at once whether the builder took trouble over the equipment.
Separate the parts from the supports with a sharp knife, sand down the pad left by a support and wash the surface in lukewarm water with dish soap. They are glued with super glue. Red covers poorly, so a white or gray primer and several thin coats pay off. A satin varnish then gives the body a fine sheen and small scrapes on the edges turn a clean part into a used thing.
The set is an accessory to a plastic kit, not a model in its own right. The kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
