PZL M18 Dromader Engine and Exhaust is a 3D-printed detail set (engine and exhausts) in 1:48 scale from IBG models. It is NOT an airplane model; it is an accessory intended for the Dromader kit from IBG.
Responsibility details are not available.
Note: this is not a complete airplane model but an add-on (upgrade) detail set. This 3D-printed set in 1:48 scale adds a finely rendered engine and exhaust system and is intended to improve the kit of the agricultural and firefighting aircraft PZL M18 Dromader from IBG models. It cannot be built on its own without the basic Dromader kit.
The radial engine and the characteristic exhausts are among the most visible features on the Dromader. The 3D-printed parts replace or complement the basic plastic parts from the box and take the detail of the engine section to a considerably higher level, with the fine texture of the cylinder fins and the exhaust pipes that injection-molded plastic manages only with difficulty.
These are resin 3D-printed parts intended for the more experienced modeler. First wash any residue off the parts (with a degreaser or lukewarm soapy water) and let them dry. Cut the print supports off carefully and sand the surfaces with protection for your airways. Glue with cyanoacrylate. Apply a primer before painting; the metallic shades of the engine and the sooting of the exhausts come out with washes and a drybrush.
It is an add-on detail set, not a stand-alone model. The matching basic kit is needed to use it and is not included in the package. Glue, paints and other accessories are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
