1:72 LAU-33 ZUNI rocket launcher for US Army & Navy (2 pcs)

Reskit 1:72 LAU-33 ZUNI Rocket Launchers (2 pcs) – Resin Armament Accessory

The set contains two resin, 3D-printed LAU-33 launchers for the unguided ZUNI rocket. This is not an aircraft model or a stand-alone kit — it is an armament accessory intended to be fitted on models of American combat aircraft in 1:72 scale. It is made by Reskit, whose 3D-printed parts offer sharper edges and finer surface detail than can be achieved with injection molding.

The real subject

The ZUNI is an American unguided 127 mm (5-inch) aerial rocket with folding fins. While the best-known ZUNI carrier, the LAU-10 series pod, carries four rockets, the LAU-33 is a twin launcher for two rockets. This type of twin launcher was used on US Navy and Marine Corps aircraft during the Vietnam War era. Structurally, it is a noticeably simpler and slimmer device than the enclosed four-round pod — that is the main difference you will notice when building it.

Working with resin

• Wash the parts in warm water with dish soap before building — this removes residue of uncured print resin.
• Cut off the 3D-printing supports with a saw or a scalpel; never snap them off, since the thin parts would crack.
• Glue exclusively with cyanoacrylate glue.
• Sand wet and with respiratory protection — resin dust is harmful to health.
• Apply a primer before the paint; resin without a base coat holds paint poorly.

Who the set is for

For modelers of American combat aircraft in 1:72 scale who want accurate, finely detailed underwing armament. Basic resin-handling skills are needed, but mounting the launchers on the pylons is fairly straightforward.

The accessory is supplied unassembled and unpainted. Glue, paints and the base kit are not included in the package.